What are the steps to changing the rear main seal in a 09 toyota camry?

Answer this question

  • What are the steps to changing the rear main seal in a 09 toyota camry?


Answer #1 | 19/12 2013 22:39
it is not remotely a DIY job, let some experts do it as the transmission has to be removed
Positive: 50 %
Answer #2 | 19/12 2013 22:53
The general idea is to remove the transmission from the engine so take everything off so you can have access to the bell housing bolts. You have to remove the flywheel and maybe the oil pan. You will most likely need to remove the engine mounts on the transmission side of the engine so you need an engine sling. A lift is preferred although doing in on jackstands is doable but a lot harder. A seal installation tool is preferred to install the seal. Rent one out from a car parts store.
Positive: 44 %
Answer #3 | 20/12 2013 08:32
Harley Drive was right based on the way you've asked. That would be my advice also. Unless you have another vehicle and want to have some headache left alone a chance to hurt yourself then go with number 2 answer (sc0rpyo_nytes) Can't be any clearer.
Positive: 24 %

Possible answer

Replacing Shock Absorbers. Most Popular ... Isn't replacing them just like changing struts, ... seal and hold it in place with a cable tie. ...
Read more
Positive: 50 %
Cost to change rear main seal? 1987 ... Ford Truck Enthusiasts Forums > Older, ... 09:39 PM g_k50. ...
Read more
Positive: 45 %
Rear Suspension Problems of Toyota Camry ... he observed that the rear struts were leaking fluid and advised ... Purchased 2010 Toyota Camry in 12/10/09.
Read more
Positive: 31 %
Engine Rebuild & Assembly Instructions. ... The first step in the cleaning process is to clean the area in which you are ... *Install the rear main seal ...
Read more
Positive: 8 %

Show more results

Login to your account
Create new account