FIND THE ANSWERS

what amplifier should I use?

Answer this question

  • what amplifier should I use?


Answers

Answer #1 | 23/12 2013 13:59
You shouldn't go over 300w rms per sub. JL actually considers them optimally powered at 200w rms each. You CAN use a 2 ch, but the most common option (and best IMO) would be a mono amp that's 500-600w rms at 2 ohms. That amp kit is borderline for the size of amp you need. It uses a 50A fuse which means it probably IS legitimate 8 awg wire, but 8 awg (50A) is on the small side for a 500-600w rms amp. Preferably you'd want a 4 awg kit with an 80-150A fuse. A couple amp examples: http://www.sonicelectronix.com/item_67857_MB-Quart -OA500.1.html http://www.sonicelectronix.com/item_43360_JBL- GTO-501EZ.html http://www.sonicelectronix.com/item_68792_Pre cision-Power-i650.1.html http://www.sonicelectronix.com/item _69440_Orion-CO1100.1M2.html decent amp kit: http://www.sonicelectronix.com/item_45056_Belva-BAK42.html
Positive: 95 %

Possible answer

Why Add a Car Audio Amplifier? ... use the lower rating and find an amplifier that comes close to that number. If the rating is a bit higher or a lower, ...
Read more
Positive: 95 %
It's not special to this circuit. It's a general idea that we can make use of in other amplifier circuits. ... It should look like the picture below.
Read more
Positive: 90 %
Use the heads (amplifier) ... Most stores should allow you. ... Cookies make wikiHow better. By continuing to use our site, ...
Read more
Positive: 76 %
Amplifier loudspeaker ohm impedance output input voltage bridging impedance no ... Can you use 4 ohm ... that the amplifier output should be ...
Read more
Positive: 53 %

Show more results