renault traffic 1.9 wont rev and cuts out?

Answer this question

  • renault traffic 1.9 wont rev and cuts out?


Answer #1 | 12/11 2013 11:19
Do or get done a injector leak back test done. A very common fault on these not being able to maintain rail pressure under load hence cuts out. If not this then You need to replace / renew the clutch pedal sensor / switch.. You may have low pressure on the diesel system but its not low enough, bad enough to cause problems otherwise you would be having starting problems etc.. Cutting out like this is down to that clutch switch as I say (located above the clutch pedal ) ...when you press it - this cutting the revs to the engine ..because you are coming to a stop / slow down.. etc.. and the switch should switch and send that info to the Ecu...( engine management computer) to tell the ecu what you have done..and teh ecu then controls the fueling etc to compensate .... With no signal going from a fault switch... you get a cut out... So renew that and that will sort this for you ... Check the wiring too , make sure the connections are all ok.. Get the new switch from a Renault dealer ..
Positive: 28 %

Possible answer

I have a Renault Trafic 1.9 dci 2002 and ... Renault Trafic 1993 . I have a Renault ... I have a 2005 Renault Trafic and the rear door won`t open from ...
Read more
Positive: 28 %
Im wondering could somebody tell me please where the egr valve is on my renault trafic seen ... just want to clean it out because ... Vauxhall vivaro 1.9 ...
Read more
Positive: 23 %
... Renault Trafic 1.9 dci Hi I have a ... the van still wont start the mechanic has ... on it fires up but when you take the easy start off it cuts out.
Read more
Positive: 9 %
Hello Fellas Got a Renault Trafic 53 Plate 1.9 Diesel , She does`nt want to start ... Renault Trafic Non ... Got a Renault Trafic 53 Plate 1.9 ...
Read more
Positive: 10 %

Show more results