FIND THE ANSWERS

Can you rebuild (not sure) of the part.It is shaft going from front of transfer case on 2004 dodge ram .?

Answer this question

  • Can you rebuild (not sure) of the part.It is shaft going from front of transfer case on 2004 dodge ram .?


Answers

Answer #1 | 20/12 2013 06:56
"going from front of transfer case" to WHERE? And WHY does it need to be rebuilt? Just guessing here, but I think you're asking about the drive shaft going to the front axle, and you have worn out Universal joints. And the answer is... YES! The parts you need are relatively inexpensive and easy to find.
Positive: 40 %
Answer #2 | 22/12 2013 11:52
Yes you can. If you have a double cardan drive shaft you will need 3 U-Joints and a ball kit that goes inside the middle of the double cardan on the transfer case side of the shaft. The parts don't cost that much around $30-$40 each. You don't rebuild the U-Joints like Dave said you replace them why would you waste 1/2 hour on each joint with a lathe all you will do is remove metal and make it weaker. You can replace all the U-Joints with new ones in less time then it will take to machine 1 on a lathe and then you still have to install it.
Positive: 34 %

Possible answer

2004 dodge ram pick up had ... gets a severe shake in the front end and can make you lose control and ... dodge ram 2500 heater will not switch to ...
Read more
Positive: 40 %
Chevy Silverado and GMC Sierra 4x4 Questions ... TRANSFER CASE REBUILD ... are you sure the front wheels also are engaged?
Read more
Positive: 35 %
2004 Dodge Ram 2500 ... use the same transfer case? I'm sure I'll find ... with a new sleeve if you buy them. I'm not going to assume my ...
Read more
Positive: 21 %
It is a serpintine belt on a 2004 GMC yukon. Can you help? $15: 1: ... Turn Signals do not work on 1998 Dodge Ram ... Will a new 273-D transfer case work ...
Read more
Positive: 10 %

Show more results