94 S10 Blazer left turn signal on the dash stays on continuously?

Answer this question

  • 94 S10 Blazer left turn signal on the dash stays on continuously?


Answer #1 | 19/12 2013 22:32
There is a flasher control under dash by driver side--go on internet -type in your vehicle 94 s10 flasher--
Positive: 54 %
Answer #2 | 20/12 2013 06:42
your trouble is under the steering wheel ! it,s the turn signal unit not kicking it off !
Positive: 48 %
Answer #3 | 21/12 2013 05:48
Turn the hazard switch on. See if both lights in the dash flash as they should. It might even go out when you turn them off. If it does not go off, disconnect the hazard switch to see if the light goes out. If it goes out, the hazard switch is the problem. If it does not go out, try disconnecting the turn signal switch to see if it goes out. If it goes out after disconnecting the turn signal switch, that is your problem. I doubt that the switches are bad. Both switches have separate contacts for the front lights and the rear. For the problem to be switch related, the front turn signal would have to be on along with the dashboard indicating light. You might have a wiring problem or a the dash circuit board is bad. The best thing to do would be to purchase a Haynes manual for your Blazer.
Positive: 28 %

Possible answer

... GMC S15 and Sonoma Electrical Problems ... One day I had a problem with the dash lights there were none, turn on the dome light the ... turn signal ...
Read more
Positive: 54 %
We reset all SRS airbag module (hard codes and soft codes) when your airbag light is ... airbag control module and the airbag warning light will turn on or ...
Read more
Positive: 49 %
Register at Automotive Forums .com Car Chat: Please Enter Your Date of Birth. Month:
Read more
Positive: 35 %
The headlight/running light switch is used as the trigger circuit which sends a signal to ... turn the switch to the "ON ... If tail lights stay on ...
Read more
Positive: 12 %

Show more results